Description
Overview:
This 0.92 m trailer light board (MPN 763 704) provides a ready-to-use rear lighting solution for general towing. The board carries two standard bulb combination lamps and is supplied pre-wired with a 3 m cable and a 7‐pin plug, allowing quick connection to vehicles equipped with a 7‐pin towing socket. At 0.92 m (approximately 3 ft) long, it suits small to medium trailers and plant transport where a compact lighting board is required. The 3 m lead gives enough reach for most light-duty trailers, roughly 3.0 m (about 9 ft 10 in) from plug to board. Bulb-type lamps allow straightforward maintenance with commonly available spares. Manufactured in the UK and supplied in a retail polybag with barcode, this board is intended for routine fleet, hire and trade use where functional, replaceable rear lighting is needed.
Key Features:
- Board length: 0.92 m (approx. 3 ft)
- Cable length: 3 m (approx. 9 ft 10 in)
- Pre-wired with 7‐pin plug (Maypole MP21B reference)
- Fitted with 2 x bulb combination lamps (Maypole MP17B reference)
- Bulb lighting for easy, low-cost lamp replacement
- UK manufactured
- Supplied polybagged with barcode for stock control
- Suitable for vehicles with a standard 7‐pin towing socket
Typical Applications:
Used as a rear lighting board on small trailers, general utility trailers, garden and camping trailers, plant and site trailers, and light car or ATV trailers. Suitable for temporary or replacement use where a trailer's built-in rear lamps are missing, damaged or being repaired. Connects to towing vehicles equipped with a standard 7‐pin plug socket via the pre-fitted 7‐pin plug (Maypole MP21B). The compact 0.92 m board is practical for short-beam or narrow trailers where a full-width bar is not required.
Also known as:
Trailer lighting board
Trailer light board 0.92 m / 3 ft
7‐pin trailer lighting board
Bulb trailer board
Rear lighting bar for trailers
Maypole part number MP251P3F3M
Product Specifications
| L&S Part No. | 763 704 |
|---|---|
| Part Type | Genuine Part |
