Description
Overview:
This Genuine Wacker Neuson carburettor gasket is a seven‐hole sealing gasket that fits selected Wacker rammers, including the BS50-2 and BS60-2. It sits between the carburettor and the engine intake to create an airtight, fuel‐tight joint that helps the engine start reliably, idle cleanly and deliver consistent power. Made from a durable, compressible, fuel‐resistant gasket material, it withstands vibration, heat and petrol/oil contact found in two‐stroke tampers. As an OEM component (part number 0165182), it matches the original dimensions and hole pattern for a precise fit, avoiding air leaks that can cause poor running, hard starting and increased fuel use. This is a Genuine Part from Wacker Neuson designed for dependable performance and straightforward maintenance.
Key Features:
- Genuine Wacker Neuson part for assured fit and compatibility (OEM 0165182)
- Seven-hole pattern matches the original carburettor and stud layout for easy alignment
- Creates a reliable seal to prevent air and fuel mixture leaks, stabilising idle and throttle response
- Durable, fuel- and solvent-resistant construction for long service life in tough site conditions
- Compressible material maintains clamping force under vibration and heat cycles
- Helps restore performance and reduce starting issues caused by worn or perished gaskets
- Straightforward to fit with basic hand tools, minimising downtime on site
- Suitable for routine maintenance or carburettor removal/rebuilds on compatible Wacker rammers
Typical Applications:
Used when servicing or rebuilding the carburettor on Wacker rammers to cure air leaks, replace damaged gaskets, or refit the carb after cleaning. Ideal for routine maintenance schedules, engine troubleshooting for erratic running, and preventative replacement during diaphragm or needle/seat work. Suits construction, utilities, landscaping and hire fleet environments where reliable compaction performance is essential.
Also known as:
Carburettor base gasket, intake gasket, carb spacer gasket, rammer carb gasket, carb mounting gasket, Wacker carb seal, engine intake manifold gasket for rammer/tamper units.
Fits Models:
BS50-2, BS502, BS60-2, BS60-2 Later, BS602
